FLTD三电极场畸变气体开关寿命特性

针对设计的一种场畸变气体开关,研究中间电极材料分别为不锈钢和黄铜条件下的烧蚀特性,结合开关寿命期间静态与触发特性的变化规律,获得决定开关寿命的关键因素,为三电极场畸变气体开关的性能优化提供理论支撑。研究结果表明,采用不锈钢和黄铜作为中间电极的烧蚀区域以及表面粗糙度均随着放电次数增加而增大,黄铜电极烧蚀较为严重且表面有明显的烧蚀圆斑,不锈钢电极则具有更高的表面粗糙度,阴阳极表面烧蚀存在明显差异,随着放电次数的增加,击穿点向电极边缘区域集中,影响开关的沿面绝缘特性,是导致开关寿命终结的主要原因。     

氮气吹扫和费托合成的脉冲过程以提高α-烯烃的选择性

费托合成可以将煤炭或者生物质气化得到的合成气转化为α-烯烃等重要的化工产品。研究将费托合成和氮气吹扫操作组合成一脉冲过程,在稳定的操作状态下保证费托合成和氮气吹扫交替进行。在传统的费托合成条件下(反应气速为2 000 h^-1,温度为497 K, 压力为 2.0 MPa, 氢碳体积比为2.0)考察了Fe-Co催化剂在脉冲过程中费托合成的活性和选择性。结果表明,N₂吹扫温度和压力分别为517 K和0.2 MPa下的费托合成的C₃烯烷比是未脉冲的相同反应条件下的九倍左右。同时,反应过程中CH₄的选择性和CO的转化率有所下降。在此基础上,通过间歇反应在固定床反应器中进行该脉冲过程,实验结果表明,利用脉冲操作在费托反应中可以获得更高的烯烃选择性。     

Pseudo‐differential operators in a Gelfand–Shilov setting

We introduce some general classes of pseudodifferential operators with symbols admitting exponential type growth at infinity and we prove mapping properties for these operators on Gelfand–Shilov spaces. Moreover, we deduce composition and certain invariance properties of these classes.     

Simultaneous determination of eight short‐chain aliphatic amines in drug substances by HPLC with diode array detection after derivatization with halonitrobenzenes

Short‐chain aliphatic amines are a class of hazardous impurities in drug substances. A simple method, involving derivatization followed by high‐performance liquid chromatography with diode array detection, has been developed for residue determination of eight aliphatic amines simultaneously in drug substances. Different halonitrobenzenes derivatization reagents were systematically compared. As a result, 1‐fluoro‐2‐nitro‐4‐(trifluoromethyl)benzene was selected since the derivatization effectively shifted the absorption wavelength to the visible region (400–450 nm), where most drug substances, impurities and even the derivatization reagent absorb very weakly. Due to the redshift effect, interference was minimized and adequately low limits of quantitation were reached (0.24–0.80 nmol/mL). Moreover, the derivatization reaction was readily carried out in dimethyl sulfoxide at room temperature for 1 h using N ,N‐diisopropylethylamine as catalyst to achieve the highest yield. Without any pre‐treatment, the derivatives were analyzed by high‐performance liquid chromatography with diode array detection. The high stability of the derivatives within 24 h at room temperature (RSD<1.04%) further facilitated the simultaneous preparation and consecutive analysis of quantities of samples. Finally, the proposed method was successfully applied for residue determination of eight aliphatic amines simultaneously in eight drug substance samples. This study could be helpful for the routine analysis and residue control of aliphatic amines in drug substances.     

Electrochemical Detection of Artemisinin Using Cobalt Sulphide/Reduced Graphene Oxide Nanocomposite

Solvothermally synthesized cobalt sulphide/reduced graphene oxide (CoS/rGO) was used to fabricate an electrochemical sensor for detection of artemisinin. Microscopic techniques were used to characterize CoS/rGO nanocomposite. The electrochemical sensor was fabricated by modifying the surface of glassy carbon electrode with CoS/rGO nanocomposite. [Fe(CN)6]^3−/4− was used as a mediator to aid oxidation of artemisinin. Differential pulse voltammetric technique was used for the detection of artemisinin. A linear range of 30–100 μM was used. Experimentally, a detection limit of 0.5 μM was obtained. Therefore, the developed sensor can be used for quality control of artemisinin.     

Light-induced Photoswitching of 4-(Phenylazo)benzoic Acid on Au(111)

Photochromic molecules can undergo a reversible conversion between two isomeric forms upon exposure to external stimuli such as electromagnetic radiation. A significant physical transformation accompanying the photoisomerization process defines them as photoswitches, with potential applications in various molecular electronic devices. As such, a detailed understanding of the photoisomerization process on surfaces and the influence of the local chemical environment on switching efficiency is essential. Herein, we use scanning tunneling microscopy to observe the photoisomerization of 4-(phenylazo)benzoic acid (PABA) assembled on Au(111) in kinetically constrained metastable states guided by pulse deposition. Photoswitching is observed at low molecular density and is absent in tight-packed islands. Furthermore, switching events were noted in PABA molecules coadsorbed in a host octanethiol monolayer, suggesting an influence of the surrounding chemical environment on photoswitching efficiency.     

复合材料柔软性对倒金字塔微结构阵列传感器性能的影响

采用模压成型方法制备了2种柔软性不同的热塑性聚氨酯/短切碳纤维/碳纳米管(TPU/SCF-CNT)复合材料复制物, 其表面上具有倒金字塔微结构阵列, 内部有SCF与CNT共同构成的导电通路. 将复合材料复制物和相应的复合材料平整片封装成柔性传感器. 结果表明, 压力作用下传感器内复制物和平整片之间的接触电阻因倒金字塔底棱的形变而显著降低. 对使用柔软性较高的复合材料封装的传感器, 虽然其相对迟滞稍大, 但压力作用下倒金字塔底棱形变量较大, 且复制物和平整片内导电通路增加量较大, 因此其在0~2.5 kPa的线性区内具有较高的灵敏度(0.32 kPa^?1). 制备的2种传感器均具有快速响应特性, 且能在500 s(约1580次)的循环压缩/释放测试(峰值压力约3 kPa)中保持较稳定的电阻响应. 研究表明, 利用模压成型的表面倒金字塔结构复合材料复制物封装成的柔性压力传感器具有良好的传感性能.     

Palatability Enhancement Potential of Hermetia illucens Larvae Protein Hydrolysate in Litopenaeus vannamei Diets

Marine feed ingredients derived from cephalopods (e.g., squid) and crustaceans (e.g., krill) are commercially used to improve the palatability of shrimp diets. Increase in global demand for shrimps has resulted in overfishing of these marine organisms and is a matter of concern. Insect protein hydrolysate could be a sustainable alternative for the possible replacement of these marine feed ingredients. During this study, four formulations: diet A (control: not containing any palatability enhancer), diet B (containing squid meal and krill oil), diet C (containing 1% insect protein hydrolysate), and diet D (containing 2% insect protein hydrolysate) were tested for (1) time required by first subject to begin feeding (time to strike) and (2) palatability in Litopenaeus vannamei. Additionally, the chemical composition of all four diet formulations was also analyzed. Results indicate that all diets had similar crude composition. The major essential amino acids in all diets were leucine and lysine, whereas eicosapentaenoic acid was the major omega-3 fatty acid in all diets. There were no significant differences between the mean time to strike for all the tested formulations. Palatability of tested formulations was found in the following order: diet D > diet C > diet B = diet A (p < 0.05), indicating that addition of squid meal and krill oil has no effect on palatability in comparison to control, whereas inclusion of insect protein hydrolysates significantly improves the palatability of formulations. Palatability enhancement potential of insect protein hydrolysate could be attributed to the high free amino acid content and water solubility in comparison to squid meal.     

Structural and Electronic Influences on Rates of Tertpyridine−Amine CoIII−H Formation During Catalytic H2 Evolution in an Aqueous Environment

In this work, the differences in catalytic performance for a series of Co hydrogen evolution catalysts with different pentadentate polypyridyl ligands (L), have been rationalized by examining elementary steps of the catalytic cycle using a combination of electrochemical and transient pulse radiolysis (PR) studies in aqueous solution. Solvolysis of the [Co^II−Cl]⁺ species results in the formation of [Co^II(κ⁴-L)(OH₂)]²⁺. Further reduction produces [Co^I(κ⁴-L)(OH₂)]⁺, which undergoes a rate-limiting structural rearrangement to [Co^I(κ⁵-L)]⁺ before being protonated to form [Co^III−H]²⁺. The rate of [Co^III−H]²⁺ formation is similar for all complexes in the series. Using E_1/2 values of various Co species and pK_a values of [Co^III−H]²⁺ estimated from PR experiments, we found that while the protonation of [Co^III−H]²⁺ is unfavorable, [Co^II−H]⁺ reacts with protons to produce H₂. The catalytic activity for H₂ evolution tracks the hydricity of the [Co^II−H]⁺ intermediate.     

电化学传感分析平台测定污水中的Cr(VI)

结合微型电化学仪器,研究了一种快速、便携、灵敏的Cr(VI)电化学传感分析平台,用于污水中Cr(VI)的检测。采用三电极体系,差分脉冲阴极溶出伏安法(DPCSV),记录伏安曲线中Cr(VI)的还原峰。Cr(VI)的溶出峰电流与其浓度在2～500 μmol L-1范围内有良好的线性关系,测得Cr(VI)的检测限为0.55 μmol L-1 (28.60 g L-1),达到了国际卫生组织（WHO）规定的饮用水中Cr(VI)的最高含量50 g L-1。测得镀铬厂废水中Cr(VI)含量为2.03 mol L-1,与国标法中光谱学分析法的结果基本一致。该法重现性好、灵敏度高,使其应用在现场实时监测环境中的Cr(VI)具有很大的潜力。